Publicité
37. Fasten the Desk Pedestal Left Side (B) to the Desk Top Panel (A) using two 35 mm Bolts (24), two Lock
Washers (10) and two Flat Washers (11).
90°
C
B
Nameplate
38. Go back and tighten all the fasteners. Now, ask for assistance to lift the unit upright and position it near
the final location.
39. To insert one assembled File Drawer into the lower frame. Extend the Ball Bearing Slide Tracks on the
panels all the way forward (including ball bearing cart). Then align the Slide Runners on the assembled
drawer with the Slide Tracks and push the drawer carefully inside until it stops.
40. Repeat the same procedure to insert the other File Drawer with name plate into the top frame.
NOTE: If the drawer does not go in smoothly, please take it out and repeat the step. If you need to
remove the drawer, please pull the drawer all the way out, then simultaneously pushes the plastic release
lever of the ball bearing slides up on one side and down on the other side, and then pull it completely out.
Assembly Instructions
11
10
24
B
R
R
A
25
Drawer Installation
FRONT
Ball bearing cart
Ball bearing cart
FRONT
Publicité
