Publicité
L
68. Pick up the Door (P) and align the hinge bases to the pilot holes on the Return Right Side (L).
69. Insert two 15 mm Nickel Screws (18) through the CENTER of oval holes and move the door up or down
to the desired position, then fasten the Hinge Bases (I1) into place.
70. Proceed to insert two 15 mm Nickel Screws (18) through the round holes and fasten into place.
71. Open and close the doors to make sure it is aligned and shut correctly. If necessary, adjust the screws for
a good fit.
72. To insert the assembled utility drawer into the return. Extend the Ball Bearing Slide Tracks on the panels
all the way forward (including ball bearing cart). Then align the Slide Runners on the utility drawer with
the Slide Tracks and push the file holder carefully inside until it stops.
Assembly Instructions
P
P
I 1
18
L
Y
38
L
DO NOT fully tighten the
FRONT
Ball bearing cart
Ball bearing cart
FRONT
Depth
Adjustment
Vertical
Adjustment
Horizontal
Adjustment
screws.
Publicité
