Publicité
REF. 54143
ESPECIFICACIONES TÉCNICAS
1.
Set the parking brake and block the wheels not being raised.
2.
Raise the vehicle to desired height and insure it is stable.
3.
Extend the post to the height of the axle or flat reinforced framed surface.
4.
Check the load locking and release handle to ensure that the tooth has been engaged on
the post .
5.
Make sure both jack stands are at an equal height and will support the load evenly when
the lifting device is removed.
IMPORTANT: Place jack stands under support points specified by the manufacturer.
DO NOT crawl under the vehicle when placing or removing stands.
6.
Slowly lower the load on to the jack stands and check to ensure the load is located on the
center portion of the saddle. If load is not located on the center of the saddle or if load is
unstable, relift the load and reposition the jack stands to ensure proper positioning before
continuing with work or repairs.
ESPECIFICACIONES TÉCNICAS
1.
Eleve con cuidado el vehículo lo suficiente como para retirar los caballetes, asegurándose de
que el vehículo permanezca estable.
2.
Retire los caballetes, asegurándose de no colarse debajo del vehículo en el proceso.
3.
Siguiendo las instrucciones proporcionadas con su dispositivo de elevación, baje cuidadosa-
mente el vehículo al suelo.
· 5 ·
Publicité
