EN
MANUAL OF INSTRUCTIONS
PRODUCT PRESENTATION
These heavy-duty jack stands are designed to hold industrial work pieces at ergonomically work
levels .
SAFETY INSTRUCTIONS
•
Study, understand, and follow all instructions before operating this device.
•
Do not overload the jack stand. Overloading can cause damage to or failure of the stand.
•
Do not exceed maximum capacity .
•
Use as a matched pair to support one end of a vehicle only.
•
Failure to heed these warnings may result in loss of load, damage to stand, and/or failure
resulting in personal injury or property damage .
•
Stands are not to be used to simultaneously support both ends of a vehicle.
•
No alterations shall be made to this product .
•
Always firmly apply the parking brake.
•
Place wheel chocks at the front and rear of the tires that will not be lifted before procee-
ding .
•
These jack stands must only be used as supporting devices .
•
Lifting must always be done with a proper capacity jack.
•
Lifting devices are only designed for use on hard, level surfaces only. Use on uneven or uns-
table surfaces could result in instability and possible failure to support load.
•
Always place load at the center of the jack stand's saddle for most stable support.
•
Always center any jack used under the axle or a flat, reinforced frame surface.
•
Inspect the jack stands before each use. Do not use if bent, broken or cracked components
are noted .
•
With hammer and punch, bend tab to retain stem into base .
TECHNICAL SPECIFICATIONS
Capacity
12T
Min. height
500 mm
Max. height
770 mm
Dimensions
375x325 mm
· 4 ·
REF. 54143
PARTS LIST