Publicité
7
8
9
10
11
12
DMX-512 connections
The DMX512 is widely used in intelligent lighting control, with a maximum of 512
channels.
If you're using a controller with an XLR 5-pin DMX output, you'll need an XLR 5-
pin/3-pin adapter.
On the last device in the DMX chain, we recommend using a "DMX plug". (a 120
Ohm 1/4W resistor between pin 2 (DMX-) and pin 3 (DMX+), placed in a male
DMX connector).
Connect the fixtures one after the other: DMX output to DMX input of the next
fixture. The DMX cable must NEVER be a "Y" cable. The DMX-512 link carries a
Strob
Dimmer
Pan/Tilt speed
Auto mode
RESET
LED ring
000-255
From slow to fast
000-255
From 0 to 100%
000-255
0-100%
000-255
Auto mode
250-255
Wait 5 sec
5-109
Color selection
110-255
Prog. Auto
18
Publicité
