Publicité
Prepare for Use:
1.
Reconnect the water, drain and electrical power supply.
2.
Turn on water and electrical power supply.
3.
Fill detergent cup and run the dishwasher through a heated wash
cycle.
4.
Check the connections for leaks.
TROUBLESHOOTING
DISHWASHER NOT OPERATING PROPERLY
PROBLEM
Dishwasher
does not
run or stops
during a cycle
Dishwasher
does not start
a cycle
Dishwasher
will not fill
38
POSSIBLE CAUSE
There is no power to the
dishwasher.
The door is not closed
tightly and latched.
Most cycles pause for
5 minutes near the start
of a cycle to let the dishes
soak.
Certain cycles repeatedly
pause for 15 to 65 seconds
during the main wash.
The Delay feature is
selected.
Control Lock feature is
activated.
Door not closed within
4 seconds of START
button being pressed
The water shutoff valve is
not turned on.
The door is not closed
tightly and latched.
Water pressure is too low.
SOLUTION
Replace fuse or reset
circuit breaker.
Close and latch the door.
This is normal, and reduces
the energy required to
clean the dishes.
This is normal.
To reset, see "Options" in
the Controls section.
Deactivate Control Lock.
See "Additional Features"
in the Controls section.
Close door within
4 seconds of pressing
START.
Turn on the water valve.
Close and latch the door.
Verify a minimum of
20 psi water pressure is
maintained during the
filling operation.
Publicité
