Publicité
7. When you hear the timer buzzer, the set preparation time has elapsed. Pull the pot out
of the appliance
Note: You can also switch off the appliance manually. To do this, set the time to 1
Tip: You can adjust temperature or time according to your taste during use. Your settings
will be kept for about 10 mins after you pull the pot out of the body
8. Check if the ingredients are ready.
If the ingredients are not ready yet, simply slide the pot back into the appliance and set
the timer to a few extra minutes.
9. To remove ingredients (e.g. fries), pull the pot out of the Hot-air fryer and place it on trial
framework, lift the fried plate out of the pan.
Do not turn the fried plate upside down with the pot still attached to it, as any excess oil
that has collected on the bottom of the pot will leak onto the ingredients.
The pot and the ingredients are hot. Depending on the type of the ingredients in the air
fryer, steam may escape from the pot.
-Empty the pot into a bowl or onto a plate.
-When a batch of ingredients is ready, the Hot-air fryer is instantly ready for preparing
another batch.
CONTROL PANEL INSTRUCTIONS
Operation Instructions:
1. After power on the machine,all pilot lamp and nixie tube are on and blink for 3 seconds and
then turn off, the buzzer sounded three times at the same time,then the power
always on;
2. Power on by pressing the power button
and time symbols are not lit,
displays say"----"
3. At this time, consumers choose pot ① or pot ② according to their needs, after selecting ①，
① and
light flicker,the corresponding menu indicator blinks, pot ① corresponding to the
display light, show default menu 180°C/15min or 360ºF/15min,temperature and time are
displayed alternately,the left and right indicator lights of the display display accordingly; pot
② the corresponding display screen displays "----".
4. Press
to select the menu, which menu to select, the corresponding menu indicator
blinks, other menu lights are always on, the display displays the temperature corresponding
to the menu, no operation is performed after 3 seconds, temperature and time are displayed
alternately; adjust the temperature and time if required, select the temperature time select
， the corresponding indicators on both sides of the display light up, press
key first
this time to adjust the temperature and time, after adjustment, press the start pause button
， indicator is on, after startup, select menu light is on, other menu lights off, the
machine goes into operation mode, the display alternates temperature and time, after work,
the menu select key
,
two lights not bright,all other lights are on normally,both
can no longer be selected;
for 0.5 seconds,after startup, the temperature
15
light is
at
Publicité
