Citizen CBM1000 II Mode D'emploi page 9

Please observe the following precautions for power source and power cord:
• Do not plug or unplug the power cord with a wet hand.
• Use the printer only at the specified supply voltage and
frequency.
• Use only the specified AC adapter with the printer.
• Check to make sure that the supply outlet from which the
printer is powered has a sufficient capacity.
• Do not plug the power cord into a supply outlet with dust or debris left
on its plug.
• Do not supply the printer from a power strip or current tap shared with
other appliances.
• Do not use a deformed or damaged power cord.
Neglecting to handle properly may result in printer failure,
emission of smoke, fire, or electric shock.
An overload may cause the power cable to overheat or the circuit
breaker to trip.
• Do not allow anything to rest on the power cord. Do not place the
printer where the power cord will be trampled on.
• Do not attempt to modify the power cord unnecessarily.
• Do not use or carry the printer with its power cord bent, twisted, or
pulled.
• Do not lay the power cord in the neighbor of a heating device.
Neglecting these cautions may cause wires or insulation to break, which
could result in leakage, electric shock, or printer failure. If a power cord
sustains damage contact your CBM dealer.
• Supply power to the printer from a convenient wall outlet,
readily accessible in an emergency.
• Do not leave things around the supply outlet to always
ensure easy access to it.
The printer may not be immediately shut down in an
emergency.
• Insert the power plug fully into the outlet.
• If the printer is not to be used for a long time period, leave it
disconnected from its supply outlet.
Do not handle the printer in the following ways:
• Do not allow the printer to sustain strong impacts or hard jolts (e.g.
trampling, dropping, striking with a hard edge).
• Never attempt to disassemble or modify the printer.
• Do not clean the printer with any organic solvent, such as
alcohol, paint thinner, trichloroethylene, benzene, or keton.
Neglecting to handle properly may result in printer
failure, overheating, emission of smoke, fire, or electric
shock.
Install, use, or store the printer out of the reach of children.
The plastic bag the printer came in must be disposed of properly or kept
away from children. Wearing it over the head may lead to suffocation.
Electric appliances could cause an unexpected injury or accident if they
are handled or used improperly.
Keep the power cord and signal cables out of the reach of children. Also
children should not be allowed to gain access to any internal part of the
printer.
— 6 —