Publicité
IC Compliance Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's license-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
L'appareil contient un émetteur / récepteur exempté de licence conforme au CNR exempté
de licence d'innovation, sciences et développement économique Canada. Les opérations
sont soumises aux deux conditions suivantes:
(1) Cet appareil ne peut pas causer d'interférences.
(2) l'appareil doit accepter toute interférence, y compris celles qui peuvent entraîner un
fonctionnement indésirable de l'appareil.
UL1973 Compliance
This battery complies with UL1973 . If you use the battery in the vehicle or marine system,
you need to make an enclosure to protect the battery. Material of the enclosure: SECC or
SGCC, thickness ≥
1.5 mm (0.06")
The following figure is a reference, and the actual dimensions of the enclosure must be
greater than or equal to the dimensions provided in the figure.
Put the battery into the enclosure, and secure the upper cover with screws.
10.4 in.
(264 mm)
Cable holes x2
Enclosure fastening
EN
1 3
Publicité
