Publicité
ASSEMBLY INSTRUCTIONS
7. Cover the operation hole on the bottom plate of
the top fountain (A) with the reservoir lid (D).
8.
cord plug
rate controller on the water pump
to the +/- signs. If the flow is not same for the two
outlets, adjust the knobs on the water flow rate control
valve assembly (C).
CAUTION:
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
9 .
Adjust the feet under the fountain base (B) to make
it level. Pour glass bead (F) into the fountain base
evenly.
of power supply
8
D
Flow rate
C
adjusting
knob
F
Publicité
