Wagan Smart AC 200W USB+ Guide D'utilisation page 4

Smart AC 200W USB+ by Wagan Tech
™
Troubleshooting
When operating a TV monitor, TV/DVD, or TV/VCR combination, picture
tube type TVs and monitors have a high initial surge of power when they
are turned on. If the device does not start up on the first try, switch the
device on every 2-3 seconds until the screen comes on. Some screens
may take 2-5 tries before starting.
If the inverter does not appear to be functioning, check the following
possible causes:
• Poor contact : Clean contact parts thoroughly.
• DC receptacle has no power: Check fuse in lighter socket circuit and
replace any blown fuse with same type and rating.
• Battery voltage is too low: Start the engine or recharge the battery.
Replace battery if needed.
• Shuts down on overload: Reduce the wattage of the load.
• Thermal shutdown: Under heavy loads for extended periods of time,
the inverter will shut down to prevent damage from excess heat.
Reduce the load and allow the inverter to cool before restarting the
inverter.
Maintenance
Little maintenance is required to keep your inverter operating properly.
Periodically clean the exterior of the unit with a damp cloth to prevent
accumulation of dust and dirt
www.wagan.com
5
User's Manual—Read before using this equipment
Specifications
AC Output voltage
DC Input Voltage
USB Output Voltage
USB Output Current
Output Wave Form
Output Power
Surge Power Capacity
Efficiency
No load Current
Battery low Shutdown
Thermal Shutdown
(Automatic Recovery)
Dimensions (L x W x H)
Weight
©2011 Wagan Corporation. All Rights Reserved
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
115 V ±5 V AC, 60 Hz
12 V (10 V to 15 V)
5 V
2.1 A
Modified Sine wave (MSW)
200 Watts
500 Watts
Over 90%
<0.15 Amps DC
DC 8.5 V ± 0.5 V
55ºF ± 5ºF
4.41 in. x 3.54 in. x 1.62 in.
112 mm x 90 mm x 41 mm
12.3 oz / 348 g
6