Wagan Smart AC 200W USB+ Guide D'utilisation page 3

Smart AC 200W USB+ by Wagan Tech
™
Operation
The plug allows the inverter to be easily connected to a cigarette lighter
socket or accessory socket in a vehicle.
For Power Cord with Cigarette Lighter Adapter Installed:
i. Insert the DC plug into the vehicles accessory socket.
ii. Turn the ignition switch to the accessory position, if necessary.
iii. Insert appliance plug(s) into AC socket(s) at the front of the
inverter.
iv. Turn on the power switch (located on the front of the inverter).
v. The green LED will light up to confirm that AC output is present.
vi. After use, turn off the inverter and disconnect the plug from the
accessory socket.
USB Power Port
When the inverter is powered, the USB Power Port provides 5
volts DC up to 2.1 Amps for charging tablets, cell phones, PDAs,
MP3 players, and other small electronics. The user supplies the
charging/power adapter cord.
Follow the instructions below to power the inverter.
i. Connect the device to the adapter cord.
ii. Plug the USB connector into thee USB port.
iii. Turn on the device.
www.wagan.com
3
User's Manual—Read before using this equipment
iv. After use, turn off the device and turn off the inverter.
v. Disconnect the USB connector from the inverter.
vi. Disconnect the inverter from its power source.
Note for Vehicle Use
This inverter has features that will prevent your battery from being
completely discharged. An automatic shutdown will initiate when the
battery voltage is 10.5 volts. If this occurs we recommend operating
your engine for 10-20 minutes to recharge the vehicle's battery.
CAUTION
• If you use a battery charger to recharge your battery, be sure to
disconnect the inverter first. Failure to disconnect the inverter prior
to connecting a charger may result in an input voltage spike that
can damage the inverter.
• Powering this inverter with greater than 15 volts DC can damage the
inverter and void the warranty.
• Do not use an extension cord between the DC power source and the
DC input of the inverter. An extension cord on the DC input can create
a voltage drop that can reduce efficiency and output.
• Do not open the case of the inverter. There are no user serviceable
parts inside.
• Do not let the cord of the inverter or any appliance cord get wet. Do
not operate this inverter in or around water. Water can damage the
inverter. Water damage is not covered under warranty.
©2011 Wagan Corporation. All Rights Reserved
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
4