Publicité
USING THE TOOL
USING THE TOOL
USING THE TOOL
USING THE TOOL
Select the dies set. Open the head and then
insert the dies into the crimping head (ball
headed dowel).
Put the connector with the cable inserted between the two dies.
CHECK THAT THE LOCK IS CLOSED CORRECTLY BEFORE CRIMPING
Press the crimping trigger until an audible "click" is heard. The LED light up (see INDICA-
TIONS LED).
CAUTION: THE DIES TIGHTEN VERY TIGHTLY. DO NOT SLIDE YOUR FINGERS IN
THE DIES PROFILE.
Press the release trigger to retract the piston.
PERFORM OTHER CRIMPINGS IN THE SAME WAY.
To remove the dies, open the head and then remove the dies.
0412 - BPL055 - 13
Slide the battery into the handle of
the press until you hear a click
KW Hydraulik GmbH – 96515 Sonneberg – Germany – www.kw-hydraulik.de
Press the button ON/OFF tool. The LED light
up (see LED INDICATIONS).
Open the head to remove
the crimping connector.
English
Publicité
