cecotec BOLERO SQUAD 3001 Manuel D'instructions page 60

ENGLISH
The isolating switch must be of an approved model and provide 3 mm contact separation
-
on all poles (or on all active [phase] conductors if local wiring regulations allow this
variation of requirements).
- If in doubt about the installation, seek advice from local building authorities and regulations.
Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) on the walls
-
surrounding the hob.
After installing the hob
The supply cord should not be accessible through the cabinet doors or drawers.
-
Make sure that there is an adequate flow of fresh air from the exterior of the cabinet to
-
the hob base.
- If the hob is installed above drawers or cabinets, you must install a thermal protection
barrier under the hob base.
The user must be able to access the isolating switch easily.
-
Fixing brackets
You must place the unit on a stable and smooth surface (you can use the packaging). Do
-
not apply force to the buttons protruding from the hob.
- Secure the hob to the counter by screwing the four brackets located on the interior part of
the hob (as shown in Fig. 7) after the installation.
Legend Fig.7:
1. Fixing bracket
Adjust the bracket position to the thickness of the counter. Fig. 8
-
Legend Fig.8:
1. Induction hob
2. Fixing bracket
3. Counter
Warning
Brackets should not, under any circumstance, touch the interior surfaces of the counter after
installation.
It is recommended that qualified personnel or technicians install the hob. You should not
-
install it on your own.
- Do not install the induction hob directly over a dishwasher, a refrigerator, a freezer, a
washing machine, or a dryer, as moisture could damage the electric system of the hob.
The induction hob must be installed in a manner that ensures the best heat radiation to
-
obtain the best results.
60