Publicité
Raise the end of the generator where the recoil starter
is located high enough to gain access to the frame bot-
tom; securely position props underneath to support.
Align the holes on the frame support with the holes on
the generator frame.
Slide a washer on the bolt, then insert the bolt through
the hole in the generator frame so it extends down
through the frame support.
Slide a washer on the bolt, then install flange nut and
tighten securely.
Repeat on other side.
INSTALLING THE WHEELS
See Figure 5.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the side
opposite the handle.
Locate the following items:
2 bolts (3/8-16 x 5-1/4 in.)
2 washers (3/8 in.)
2 spacers (.38 ID)
2 wheels
2 lock nuts (3/8-16)
Raise the end of the generator opposite the handle high
enough to gain access to the frame bottom; securely
position props underneath to support.
Insert a wheel spacer into the center of the wheel.
Place a washer on the bolt, then slide bolt through the
wheel.
Slide the bolt through the U-bracket frame on generator.
Install nut and tighten securely.
Repeat the process on the other side to install second
wheel.
ATTACHING THE HANDLE
See Figure 6.
Locate the following items:
2 handles
2 bolt (5/16-8 x 3/4 in.)
4 washers (5/16 in.)
2 lock nuts (5/16)
2 handle bracket spacers
Place handle and spacer on the frame.
Place a washer on a bolt, then slide bolt through the
handle, the frame and the spacer.
Install nut on bolt and tighten securely.
Repeat the process on the other side to install second
handle.
ASSEMBLy
LOCKING THE HANDLES
See Figures 7 - 8.
Locate the following items:
2 handle lock pins
2 lanyards
Attach the lanyard to the handle lock pin and the handle
as shown in figure 7.
Extend the handle, then insert the pin through the hole
in the handle and the generator frame to secure handle
in place.
Repeat the process on the other side to lock the other
handle.
CAUTION:
Do not attempt to lift the unit by the handle assembly. If
it is necessary to lift the generator, always grasp by the
frame. Use proper lifting techniques to avoid back injury.
RELEASING THE HANDLES
Remove the handle lock pins and lower the handles to
the down position.
WARNING:
To reduce the risk of electrocution or explosion, do not
short circuit the battery terminals or charge in a sealed
container. Keep sparks and flame away.
WARNING:
Keep metal objects away from the battery terminals.
Metal objects can make a connection from one terminal
to another. Shorting the battery terminals together could
cause sparks, burns, or a fire.
CONNECTING/DISCONNECTING BATTERy
See Figure 9.
The battery cables must be connected before the electric
start feature of the generator can be operated.
To connect battery cables:
Connect the red wire to the positive (+) terminal first,
then connect the black wire to the negative (–) terminal.
Make sure all connections are tight.
NOTE: Be careful not to short across the terminals when
installing. Shorting the terminals together can cause
sparks, damage to the battery or generator, or even
burns or explosions.
Cover the terminals with the rubber covers.
When removing the battery for replacement: disconnect
the negative (black) post, then the positive (red) post, being
careful not to short across the terminals. Always abide by the
safety warnings provided with the battery. Remove the bat-
tery and dispose of according to local and state regulations.
Page 12 — English
Publicité
