Publicité
Handheld Operation
Charge Up
1. Remove battery insulating tab: pull firmly.
For convenient charging and storage, we recommend
installing the handheld unit into the mopstick and
placing on the charging & storage dock - see p.21 for
detailed instructions.
To charge handheld unit directly, follow these steps:
2. Open upper battery cover: grasp top edge and pull
out firmly to "snap" cover open.
3. Connect power adapter to charging port and insert
plug securely into outlet socket.
4. Charge indicator light will illuminate
when successfully connected:
> charging: blinking green light
> fully charged: solid green light
Note: Full charge requires approximately 2.5 hours
5. When ready to use, unplug power adapter.
6. Lift battery cover back up and press firmly inward
to "snap" cover securely closed.
Power Up
Normal Power
1. Press power button to turn unit on
> normal mode: solid green light
2. Press power button again to turn
unit off.
Turbo Power
While vacuum is running in normal mode
1. Press turbo button to activate Turbo
Mode for enhanced suction power.
> turbo mode: solid blue light
2. Press turbo button again to return to
normal mode.
Online
Help
Videos
18
1
TA B
4
3
2
1
Typical Run Times:
1
On-Board Brush Tool
Push in and slide switch down to
extend on-board brush bristles.
See p.21
!
Use
WA R N I N G
only the charger provided
to recharge your Nugeni
vacuum. Charge vacuum
with standard electrical
outlet only (120V/60Hz)
H A N D H E L D
22
Normal Mode:
min.
18
Turbo Mode:
min.
mynugeni.com
Publicité
