Publicité
Step 2
å
Turn six ANGLED HEAD CAM SCREWS (3) into the LEFT UPRIGHT (C).
å
Fasten two RIGHT CABINET RAILS (II) to the LEFT UPRIGHT (C). Use six BLACK 1/2" FLAT HEAD SCREWS (18)
through the 2nd, 3rd, and 5th holes as shown.
å
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
prepared, the parts are greasy.
å
Fasten the LONG EXTENSION RAIL (EE) to the LEFT UPRIGHT (C). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the upper diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other two holes that line up with the holes in the LEFT UPRIGHT. Turn
the SCREWS into those holes.
å
NOTE: The LONG EXTENSION SLIDE will be used later for the LARGE DRAWERS.
Use this hole.
7
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
4
5
5
3
(6 used)
1
Page 6
Use these holes.
EE
Push the black lever down and pull the SLIDE from the RAIL.
18
1
2
3
1
2
II
3
II
4
C
www.sauder.com/service
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
Roller end
EE
1
FF
20
Open end
Angled head
7
433362
Publicité
