3. TECHNICAL DATA
MODEL
TECHNICAL DATA
Pow er supply voltage
Frequency
Number of plates
Max. pow er plates
Max. pow er oven
Nominal maximum power
Pow er supply cable section
4. OPERATING INSTRUCTIONS
CAUTION:
Use the equipment only under guard.
The equipment must never works without water.
IGNITION
Activate the master switch.
4.1 Electric plate
Turn the knob on the selected position among "1" and "6" (Fig. 1). The pilot lamp lights up.
To start with the highe temperature is advisable; when the temperature is reached turn the knob on a lower position. To switch
off turn the knob on position ●
4.2 Electric oven
The resistors are positioned in the ceiling (higher heat) and under the chamber (lower heat). The temperature is regulated
between 50 and 280¡C by means of two thermostats which control the resistors independently. In order to light the oven and
regulate the temperature turn the knob of the thermostat to the required temperature setting.
CAUTION: Before starting maintenance work, remove the pilot light or disconnect the switch placed upstream.
A safety thermostat can turn out the higher resistor (in the ceiling) in the event of malfunctioning. In the event of faulty working
switch the appliance off and call the service centre.
CM920G
CM940G
V
Hz
Nr.
1
kW
7
kW
-
kW
7
mm2
● Plate out
1 _ To keep food warm or to melt the butter.
2 _ Continous cooking of small quantities.
3 _ Continous cooking of big quantities
4 _ Medium temperature cooking.
5 _ High temperature cooking.
6 _Only in the beginning and for 5-10 minutes max
900
CM920G
400-3N
50/60
2
1
14
7
-
-
14
7
700
CM940G
CM920G
2
1
14
7
-
-
14
7
CM940G
2
14
-
14