Publicité
11. Align bottom connector plate with holes in pedestal
desk and return desk. Use two #8 x 1/2" screws and
one #8 x 1/4" screw to secure. (See Figure 7)
NOTE: Remove #8 x 1/4" screw from bottom
connector plate before you install it. Once
bottom connector plate is aligned, use same
#8 x 1/4" screw to secure plate.
Figure 7
#8 x 1/4" Screw
Bottom
Connector
Plate
PAGE 3 OF 9
ASSEMBLY CONTINUED
12. Extend drawer slides on underside of desk top.
Figure 8
#8 x 1/2" Screw
13. Adjust floor glides to compensate for uneven floors.
14. Place drawer dividers at desired locations in top
1-800-295-5510
uline.com
Pull ball bearing carrier forward and install center
drawer into the extended slides. (See Figure 8)
Drawer Slide
Ball Bearing Carrier
drawers and insert grommets into desktop.
0124 IH-8204
Publicité
