Publicité
FIRST USE
When using the device for the first time or for the first time after a long break, it is
recommended to fill it with water up to the maximum allowed water level (fig. B) and
to boil the water 1-2 times. Water boiled the first 1-2 times should be discarded.
USE AND FUNCTIONS
Place the device on a flat and stable surface.
•
Connect the device to a power source. The device will beep and the on/off
•
switch icon (6, fig. A) will flash. The device is now in standby mode.
Start the device by pressing the on/off switch icon (9, fig. A). Then select one
•
of the available options - boiling water, maintaining temperature or purifying
water.
Press the on/off switch icon (9, fig. A) to switch the device off at any time
•
during operation.
BOILING WATER
Press the settings icon (7, fig. A) to select boiling water (12, fig. A).
•
Use the plus and minus icons (5, 6, fig. A) to set the temperature you want
•
the water to reach. The temperature can be increased or decreased in 5°C
increments.
After a few seconds the water will start to boil. The device will automatically
•
switch off when the water boils.
MAINTAINING THE TEMPERATURE
Press the settings icon twice (7, fig. A), then select temperature maintenance
•
in the display (11, fig. A). The device will automatically enter the current water
temperature maintenance mode.
If you wish to increase the maintained temperature, use the plus button (5, fig.
•
A). The water will then start to boil until the selected temperature is reached.
If you wish to reduce the temperature maintained, use the minus button (6,
•
fig. A).
WATER PURIFICATION - DECHLORINATION
Fill the kettle with water to a maximum of 3/4 volume.
•
Press the settings icon (7, fig. A) and then select water purification on the
•
display (10, fig. A). The water will boil and then enter water purification mode
for approximately 5 minutes.
When the purification process is complete, the kettle enters temperature
•
maintenance mode.
CLEANING AND MAINTENANCE
To ensure normal operation, clean the kettle regularly and remove any scale
•
or sediment from the bottom.
Before cleaning the device, make sure it is disconnected from the power
•
source. Allow the device to cool down.
Wipe the outside of the kettle with a soft, damp cloth and allow to dry
•
completely.
EN
5
Publicité
