General Safety Regulations - ABAC 8973005906 Manuel Utilisateur

• Do not use the equipment without the required safety devices.
• Never hold the tool from the compressed air hose when carrying it.
• Do not let other people approach the work area.
• Do not aim the air jet or the tool in your direction or towards any other third party.
• By all means, avoid direct contact with the tool engaged immediately after having used it, as its surface may
be very hot.
• Do not touch the equipment moving parts during its operation.
• Do not open nor modify in any way the tool or its accessories. Any repair should be carried out only by
trained staff.
• If working with metal, remember to direct the cutting so that it does not constitute a hazard, for the
operator or other by-standers.
• Connect compressed air only when the equipment is shut down.
• For tool optimum performance, make sure hose and connection size are those required.
• Before starting up the tool, check its connection and make sure the compressed air hose is not damaged.
• Choose and replace the engaged accessory according to the instructions in the manual, in order to prevent
unnecessary noise.
• Use accessories that are suitable for the application and that are in compliance with the device, and connect
them properly. Check that they are being used as per instructions and that they are correctly installed.
• Check the wear status of the tools and accessories before every use. Replace them if necessary.
• In case of tool replacement, during maintenance operations and when finished working disconnect
compressed air connection.
• Disconnect the tool only when the hose is NOT pressurized in order to avoid its uncontrolled motion.
• Keep the work area neat.
• Make sure the tool has come to a full stop before you lay it on the ground
• Store the pneumatic tool clean and in a dry place
• Always make sure the work station is steady.
• Firmly hold the work piece with a clamp or a fixing tool.
• Use the tool only for its original application. The manufacturer waives any liability for damages arising out
of the non observation of safety regulations or for tool misuse.
• Use only accessories that are suitable for the tool in use.
• Use only SAE 5 or SAE 10-type oil.
• Pneumatic tool and more specifically demotion hammers generate vibrations. An extended use and a wrong
posture may cause damage to hands, fingers and elbows. Immediately pause using the product as soon as
you feel any pain, tingling sensations or any other disorder. Should the problem persist, seek a physician's
advice before resuming your work.

GeNeRAl SAfeTy ReGUlATIONS

WhAT yOU ShOUlD
WhAT yOU ShOUlD DO
NOT
DO
9
GB