Publicité
Attach Top Mounting Bracket
1. With the rim of a mounting bracket pointing down, align the
holes in the bracket with the top pair of slots in the back
panel.
2. Working from the back, insert two carriage bolts through the
bracket and back panel as shown.
A
A. Carriage bolts
B. Bracket rim
3. Working from the cabinet interior, fasten each bolt with a
washer and a hex nut.
4. Slide the bracket to the very top of the slot and fully tighten
the nuts.
Attach the Middle and Bottom Mounting Brackets
1. With the rim of a mounting bracket pointing down, align the
holes in the bracket with the top pair of slots located in the
middle section of the back panel.
2. Working from the back, insert two carriage bolts through the
bracket and back panel.
3. Working from the cabinet interior, fasten each bolt with a
washer and a hex nut. Hand tighten only, as this bracket will
need to be adjusted to mount the cabinet on the wall.
4. Repeat above steps to attach bottom mounting bracket to
the lower section of the back panel.
IMPORTANT: Fully tighten the nuts on the middle and bottom
brackets after mounting the cabinet to the wall, See "Mount the
Cabinet to GearWall
Panels or GearTrack
®
Mount the Cabinet to GearWall
Panels or GearTrack
IMPORTANT:
Be sure the GearWall
®
■
installed with mounting screws in every slot and at every
stud location with a maximum of 24" (60.96 cm) horizontally
between screws.
If GearTrack
channels will be used to support the Gladiator
®
■
Tall GearBox cabinet, they must be installed 18" (46 cm)
apart.
18" (46 cm)
Channels."
®
Channels
®
panels or GearTrack
channels are
®
NOTE: The two nuts on the middle and bottom mounting
brackets must be loose enough to allow the brackets to move in
the slots on the cabinet.
1. Close the cabinet doors.
2. Determine cabinet mounting location on GearWall
GearTrack
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
3. Using two or more people, engage the top bracket into the
slot by lifting up, pushing toward the wall and lowering the
B
bracket rim into the slot as shown.
4. Make sure the top bracket is fully engaged in the slot as
shown.
A
5. Open the cabinet doors.
6. From inside the cabinet, grasp the bolts in the middle bracket
and adjust the bracket until it aligns with the slot in the
GearWall
7. Push the cabinet toward the wall and lower the middle
mounting bracket into the slot.
8. Make sure the middle bracket is fully engaged in the slot as
shown.
9. Repeat for the bottom bracket.
®
10. Using a 1/2" wrench, fully tighten the nuts attaching the
middle and bottom mounting brackets.
®
channels.
®
WARNING
Excessive Weight Hazard
B
C
A. Bracket rim
C. Bracket fully
B. Slot
panel or GearTrack
channel.
®
®
panels or
®
engaged
3
Publicité
