Publicité
This section explains how to record from the tuner, CD player, or
!xternal equipment.
/OREC/
REC MUTE
b/4b
u
L -
-----
J
Preparation
Use Type I (normal) tapes only.
Set the tape' to the point where recording will start.
Note that recording is done on only one side of the tape,
1
2
3
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
. A PUSH EJECT
I
UIJ
Press function (CD, TUNER or VIDEO/AUX)
and
prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press VIDEO/AUX.
Press
REC/REC
MUTE to start recording.
When recording from a connected source, start play~ack of
the source.
m
When the selected function is CD, playback and recording
start simultaneously.
To stop recording,
press 9.
To pause recording, press II. (Applicable when the source is
TUNER or VIDEO/AUX)
To resume recording, press it again.
Sound adjustment
during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting of the recording.
,-...,.,.,.,..%-,,,,...,,,,,
,m. *,m.,, ,-,,* *,.,,,,:*' ' -'-
..,,. wak,= ........ .
—....
w .**,-:.* m.@,m.=-,**xw$w3
!w,*,w*
M*%:
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.)
1
2
Press
REC/REC MUTE during recording or while in
recording pause mode.
~
on the display flashes for
4
seconds and 4-second blank
space is made. Then, the deck enters the recording pause
mode.
Press II to resume recording.
To insert a blank s~ace of less than 4 seconds, press
REC/REC MUTE again while ~
is flashing.
To insert blank s~aces of more than 4 seconds, after the deck
enters recording pause mode, press
REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is
added.
About cassette tapes
. To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
120-minute
o r longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use, Slack tape may break or jam in the mechanism.
m
"CAN'T REC" is displayed if you attempt to record on a tape with
the plastic tabs broken off.
To start recording with the remote control
First press
/0 REC/REC MUTE, and then press W<>
within
2 seconds.
16
ENGL/SH
To erase a recording
Make sure the microphone is not connected to this unit.
Turn MIC MIXING control to MIN (See page 22).
1 Insert the tape to be erased into deck 2 and press TAPE DECK
1/2 to display "TP 2.
2 Set the tape to the point where the erasure is to be started.
3 Press
REC/REC MUTE to start the erasure.
Publicité
