Publicité
CONTROLS AND FEATURES
1.
BT Connection button
2.
Volume control Channel 1
3.
Volume control Channel 2
4.
Input channel 2 3.5mm jack and RCA
5.
Combo input channel 1 XLR and Jack
6.3mm
6.
DSP mode
7.
LED Indicator
Limit: audio reaches the dangereous
threshold for the transducers, LED
lights RED.
Signal: indicates the input signal ''XLR''
LED lights GREEN
Power: indicates the system is "ON"
LED lights BLUE
8.
Volume control BT
9.
Output button, Choose input channel 1 only or MIX
10. Output XLR-connector
DSP SPEAKER MODE
In below schedule is the DSP frequency range of all four modes. The black line in the middle is the zero. You can
see the type of frequency of each DSP speaker mode.
Description:
RED = PA
BLUE = MONITOR
GREEN = SUB
YELLOW = SPEECH
PA mode:
This is the default setting for the loudspeaker. Use this setting when your loudspeaker is being used on a speaker
stand.
Monitor mode:
Use this setting when your loudspeaker is being used as a stage monitor.
Sub mode:
Use this setting when combined with a subwoofer. Low-frequency is filtered out of speakers.
Speech mode:
Use this setting when your loudspeaker is being used for speech or presentations.
BT- CONNECTION
1. Turn the power ON, press the pair button for two seconds, the paired LED will flash.
2. Enable BT on you device and select MIXER-01 as the device. When paired successfully, the paired LED is
light solid.
3
Publicité
