Télécharger Imprimer la page

Tagu POWERFLAME 23PF1 Instructions De Montage page 21

Publicité

NOTE: A 13 amp, 240 volt circuit is required. A dedicated circuit is preferred but not
essential. A dedicated circuit will be required if the circuit breaker trips or fuse blows on
a regular basis when the heater is operating. Additional appliances on the same circuit
may exceed the current rating of the circuit breaker.
WARNING: Don't use the firebox with regular extension cords. If the cord is not long
enough you may use only special extension cords rated for a minimum of 13 Amps.
Make sure the unit is turned OFF and unplugged before cleaning the heater or fireplace.
We recommend periodic vacuuming of the fan/heater.
Remove dust with clean dry cloth.
Remove fingerprints and other marks from glass screen by using a clean damp cloth. Do not use
abrasive cleaners or spray liquids on the glass window surface.
The remote control works with 2 x AAA 1 .5 V standard batteries .
NOTE: Please always dispose of batteries at a suitable
recycling point.
CAUTION:
Always purchase the right size and grade of battery most suitable for the intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery installation.
Ensure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment which is not to be used for an extended period of time.
Remove used batteries promptly.
Do not mix old and new batteries .
Do not mix alkaline, standard (carbon zinc), or rechargeable (nicd, nimh, etc .) batteries .
Do not ingest batteries .
CONNECTING TO POWER
CARE AND MAINTENANCE
REPLACING THE BATTERY
AAA1.5V
+
AAA1.5V
+
21
EN
!

Publicité

loading

Produits Connexes pour Tagu POWERFLAME 23PF1