Publicité
EN
4. Display
A. Temperature
B. Mode indicator
5. Main switch
6. Air outlet grille
7. Handle
8. Air inlet
9. Tip-over switch
3. OPERATING
Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of stainless steel and was coated
with protection oil by production. The smoke is
caused by the left oil when heated.
Placing the electric heater
• Place the heater upright on a firm and a level
surface.
• Keep a minimum distance of 1 m between the
front of the housing and walls and 30 cm from
all other housing surface areas. Keep away from
wet environments.
Warning! Make sure to place the heater in a
safe spot, so you cannot easily trip over the
machine and cable. Make sure to place the
heater where it cannot fall down/ of.
Starting the electric heater (Fig A, B, C)
• Plug in the cable to the mains power outlet.
• Turn the main switch (5) on.
• Press the on/off button (2C) to start the heater.
The last setting has been saved. Press de mode
button (2D) to change the heating mode.
- Fan: the mode indicator (4B) will show one
dot. The indicator light (3) will turn blue.
- Low heating mode – 100W: the mode indicator
(4B) will show two dots. The indicator light (3)
will turn green.
- High heating mode – 2000W: the mode indica-
tor (4B) will show three dots. The indicator light
(3) will turn red.
6
Adjusting the temperature (Fig. B, C)
• By default, the ambient temperature is shown
on the display (4).
• The last setting has been saved. The temperatu-
re can be set between 16
• Set the temperature as desired by press the
temperature / timer increase or decrease but-
ton (2A, 2B).
• The target temperature will keep flashing for 5
seconds after the last button press, then the
display will show the ambient temperature.
• The display dims after one minute of inactivity.
Constant room temperature
The heater starts and stops automatically to keep
the room temperature constant. Once the ambient
temperature in the room reaches the desired target
temperature, the heating element will be in standby
mode. Once the ambient temperature starts to
decrease, the heating element will be switched on
again.
Oscillation button (2E)
Press the oscillation button to activate the heater
to swing. Press it again to deactivate.
Set the timer
The timer can be set between 1 hour and 9 hours.
Hold on the mode button (2D) for 5 seconds. The
display (4) shows flashing the duration currently
set for 5 seconds. Press the temperature / timer
increase and decrease button (2A, 2B) to set the
timer with 1 hour intervals.
The display (4) alternately shows the set timer and
ambient temperature. Without a timer there is no
limit.
Tip-over switch (9)
This heater has an mechanical tip-over protection.
This protection ensures when the heater is not
placed upright on a firm and level surface or when
the heater tip over, the system will automatically
shut the heater off. If this occurs, put the heater on
a firm and level surface and start the heater again.
Automatic Overheat Safety Control
This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut the heater off.
If this occurs, the heater can only resume after
C and 37
C.
o
o
WWW.VONROC.COM
Publicité
