Télécharger Imprimer la page

Edesa EIM-6330 HT A Manuel D'instructions page 32

Masquer les pouces Voir aussi pour EIM-6330 HT A:

Publicité

EN
- There is no warm-air leakage from the oven towards the hob.
- Suitable air inlets are provided as shown in the figure.
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing. (F6)
For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
Be sure the thickness of the work surface is at least 30mm.
Under any circumstances, make sure the induction hob is well ventilated and the air
inlet and outlet are not blocked. (F7)
Stretch out the supplied installation joint along the underside edge of the hob, ensuring
the ends overlap.
Do not use adhesive to fix the hob into the worktop.
Place the hob into the cutout in the worktop (F8). Apply gentle pressure downwards
onto the hob until it is fitted, ensuring a good seal around the outer edge.
Before you install the hob, make sure that
The work surface is level and made of a heat-resistant material. Also the walls near
the hob must be heat-resistant.
The hob will not be installed directly above a dishwasher, fridge, freezer, washing
machine or clothes dryer, as the humidity may damage the hob electronics.
The installation will comply with all clearance requirements and applicable
standards and regulations.
When you have installed the hob, make sure that
The power supply cable is not accessible through cupboard doors or drawers.
If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
Disconnect the appliance from the mains electricity supply before carrying out any
work or maintenance on it.
Connecting the hob to the mains power supply (F9)
Wire colour code:
A) Black
B) Brown

Publicité

loading

Ce manuel est également adapté pour:

Eim-6330 ht bEim-6331 ht bq bEim-6330 aEim-6330 bEim-6422 bEim-6328 b wh ... Afficher tout