Publicité
Installing
T he ins tallation of the device has to be built and constructed in
a way that it can hold 10 times the weight for 1 hour without
any harming deformation.
T he ins tallation mus t always be s ecured with a s econdary
s afety attachment, e.g. an appropriate catch net. T his s econdary s afety attachment must be
constructed in a way that no part of the ins tallation can fall down if the main attachment fails.
W hen rigging, derigging or s ervicing the fixture s taying in the area below the ins tallation place, on
bridges , under high working places and other endangered areas is forbidden.
T he device s hould be installed outs ide areas where pers ons may walk by or be s eated.
IMPORTANT! OV E R HE AD R IG G ING R E QUIR E S E XT E NS IV E E XP E R IE NC E , including (but not
limited to) calculation working load limits , installation material being us ed, and periodic s afety
ins pection of all ins tallation material and the device.
T he device has to be ins talled out of the reach of people.
If the device s hall be lowered from the ceiling or high jois ts ,
profes sional trus sing s ys tems have to be us ed. T he device mus t
never be fixed s winging freely in the room.
Caution: Devices may caus e s evere injuries when cras hing down! If
you have doubts concerning the safety of a pos sible ins tallation, do
NOT ins tall the device!
ı DANGER OF FIRE! W hen installing the device, make s ure there is
no highly-inflammable material (decoration articles, etc.) within a
dis tance of min. 0.5 M.
Mount the device with the mounting-bracket to your truss ing s ystem
us ing an appropriate clamp. T he hole in the mounting bracket has a
diameter of 13 mm.
F or overhead us e, always install a s afety-rope that can hold at leas t
10 times the weight of the fixture. You mus t only us e s afety-ropes
with s crew-on carabines . P ull the s afety-rope through the hole in
the mounting-bracket and over the truss ing s ystem etc. Ins ert the
end in the carabine and tighten the s afety s crew.
Adjust the des ired inclination-angle via the mounting-bracket and fix
the fixation s crews .
ST 50W LED
OPERATING INSTRUCTIONS
1.T R US S ING
2.S AF E T Y -R OP E
3.S C R E W -ON
C AR AB INE
4.S AF E T Y -S C R E W
5.HOOK
5
Publicité
