Remote Control; Aux Playback - Hama PR-2120 Mode D'emploi

5. Getting Started

5.1 Remote control

• Open the battery compartment cover. It is located on
the rear of the remote control.
• Pull the closing tab back (if present) and lift the cover.
With other models of remote control, it suffices to
simply push the casing in the direction indicated.
Sliding cover
Insert the batteries, paying attention to match the
polarities correctly. The correct polarity is indicated
by the plus and minus symbols in the battery
compartment.
5.2 Speaker
• Connect the two satellite speakers with the
corresponding audio outputs at the rear of the
subwoofer, as shown in the wiring diagram Point 4.
• Then connect the corresponding AUX audio input
with the signal source (computer/DVD/Blueray/MP3
player etc.), with the help of one of the enclosed
audio cables.
• Connect the subwoofer's power supply cable to an
undamaged electrical socket which has been installed
correctly.
8
Note
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• When using a mult-socket power strip, make sure
that the sum power draw of all the connected
devices does not exceed its maximum throughput
rating.
• If you will not be using the product for a long
period of time, disconnect it from mains power.
5.3 On/off switch / standby
• Turn the speaker system on by turning the on/off
switch ON/OFF at the rear of the subwoofer to ON.
• Turn the speaker system off completely by turning
the on/off switch ON/OFF on the rear side of the
subwoofer to OFF.
• When the speaker system is turned on press
the POWER button on the remote control or the
MODE button on the subwoofer's front display for
approximately 3 seconds to switch the speaker system
to standby mode.
• Press the POWER button in standby mode on the
remote control or the MODE button on the front
display of the subwoofer to activate the speaker.
Note – Automatic standby
• Please note that the speaker system switches to
standby mode after 15 minutes of no activity (no
audio playback / no other activity).
• Press any button on the remote control or the
subwoofer to re-activate the speaker system.
6. Audio source selection

6.1 AUX playback

• Press the INPUT button on the remote control or
the MODE button on the subwoofer several times to
select the AUX connection as the audio source. The
AUX selection is shown on the subwoofer's display
and signalled by an "AUX" speech message.