Télécharger Imprimer la page

Tanaka TRB 24EAP Instructions De Sécurité Et Mode D'emploi page 4

Publicité

English
WARNINGS AND SAFETY
INSTRUCTIONS
Operator safety
○ A dust fi lter mask should be worn during
operation.
○ Always wear a safety face shield or goggles.
○ Always wear heavy, long pants, boots and
gloves. Do not wear loose clothing, jewelry, short
pants, sandals or go barefoot. Secure hair so it is
above shoulder length.
○ Do not operate this tool when you are tired,
ill or under the infl uence of alcohol, drugs or
medication.
○ Never let a child or inexperienced person operate
the machine.
○ Wear hearing protection. Pay attention to your
surroundings. Be aware of any bystanders who
may be signaling a problem. Remove safety
equipment immediately upon shutting off engine.
○ Wear head protection.
○ Never start or run the engine inside a closed
room or building. Breathing exhaust fumes can
kill.
○ Keep handles free of oil and fuel.
○ Keep hands away from moving part or heated
area.
○ Do not grab or hold the unit by the blow pipe.
○ When the unit is turned off make sure the engine
has stopped before the unit is set down.
○ When operation is prolonged, take a break from
time to time so that you may avoid possible
Hand-Arm Vibration Syndrome (HAVS) which is
caused by vibration.
WARNING
● Antivibration systems do not guarantee that
you will not sustain Hand-Arm Vibration
Syndrome
(HAVS)
syndrome. Therefore, continual and regular
users should monitor closely the condition
of their hands and fi ngers. If any symptoms
of the above appear, seek medical advice
immediately.
● This unit/machine is intended for occasional
use.
● If you are using any medical electric/
electronic devices such as a pacemaker,
consult your physician as well as the device
manufacturer prior to operating any power
equipment.
4
or
carpal
tunnel
Unit/machine safety
○ Inspect the entire unit/machine before each use.
Replace damaged parts. Check for fuel leaks and
make sure all fasteners are in place and securely
tightened.
○ Replace parts that are cracked, chipped or
damaged in any way before using the unit/
machine.
○ Make sure the safety guard is properly attached.
○ Keep others away when making carburetor
adjustments.
○ Use only accessories as recommended for this
unit/machine by the manufacturer.
WARNING
Never modify the unit/machine in any way.
Do not use your unit/machine for any job
except that for which it is intended.
Fuel safety
○ Empty the fuel tank before storing the tool. It is
recommended that the fuel be emptied after each
use. If fuel is left in the tank, store so fuel will not
leak.
○ Fuel contains highly fl ammable and it is possible
to get the serious personal injury when inhaling or
spilling on your body. Always pay attention when
handling fuel. Always have good ventilation when
handling fuel inside building.
○ Mix and pour fuel outdoors and where there are
no sparks or fl ames.
○ Use a container approved for fuel.
○ Do not smoke or allow smoking near fuel or the
unit/machine or while using the unit/machine.
○ Wipe up all fuel spills before starting engine.
○ Move at least 10 ft (3 m) away from fueling site
before starting engine.
○ Stop engine before removing fuel cap.
○ Store unit/machine and fuel in area where fuel
vapors cannot reach sparks or open fl ames
from water heaters, electric motors or switches,
furnaces. etc.
WARNING
Fuel is easy to ignite or get explosion or
inhale fumes, so that pay special attention
when handling or fi lling fuel.
Blowing safety
○ Operate
unit/machine
hours-not early in the morning or late at night
when people might be disturbed. Comply
with times listed in local ordinances. Usual
recommendations are 9:00 a.m. to 5:00 p.m.,
Monday through Saturday.
○ Never direct discharge of air toward bystanders
nor allow anyone nearthe area of operation.
Use care in directing discharge to avoid glass
enclosures, automobiles, etc.
only
at
reasonable

Publicité

loading