Publicité
Instruction Manual
EK 60/22-L
4.3 Mounting instructions
Please read the assembly instructions in our general ca-
talogue.
Attention
Even if the code number is identical only those
dies should be used which are suitable for the
material.
4.4 Service and maintenance instruction
For every day service the unit has to be cleaned and dried
after each use. The battery cartridge and the charging unit
have to be protected against humidity and dust.
The electric-hydraulic unit is equipped with a controller
enabling the user to see when the next service is due by
fl ashing for 20 sec. at the end of a working cycle. When
the next service is due the unit must be returned to an
authorised service center (ASC). Failure to observe this
request results in loosing the Guarantee. Preventive
maintenance serves your safety.
Within the determined use of the tool only the dies are
permitted to be changed by the customers.
Attention
Do not damage the seals of the tool. If the seals
are damaged the warranty is invalidated.
5.
Troubleshooting
a.) Constant fl ashing/indicating of the light diode display
(pic 1.1) or the occurence of an acustical warning
signal.
see table 1. If the failure can not be solved through
the action recommended in table 1 return the tool to
the nearest service center (ASC).
b.)
The tool loses oil.
Return the unit to the manufacturer. Do not open it
and damage the seal of the tool.
c.) The red LED fl ashes 3x and simultaneously 3 accustic
warning signals occure (see table 1).
Serious fault! If this fault occures repeatedly return
the unit to an Autorized Service Center (ASC). Do
not open it and damage the seal of the tool.
In case of a one time occurence the connector has
to be crimped a second time.
HE.13427 © 08/2009
6.
Technical Data
Weight
approx. 4,2 kg
(incl. battery):
Crimping force:
approx. 60 kN
Driving motor:
direct-current permanent fi eld
Battery voltage:
18 V DC
Battery capacity:
3 Ah (RAL2/BL1830)
Charging time:
22 min. (RAL2/BL1830)
Crimping time:
approx. 3 s to 6 s
(depending on the connector size)
Crimp per battery:
approx. 300 crimps
(Cu 150 mm² DIN 46235)
Hydraulic oil:
Rivolta S.B.H. 11
Environmental
-20°C bis +40°C
temperature:
Sound level:
70 dB (A) in 1m distance
Vibrations:
< 2,5 m/s²
Dimensions:
See pic. 2
7.
Putting out of operation/waste dis-
posal
This unit is subjected to the scope of the European WEEE
(2002/96/EG) and RoHS (2002/95/EEC) directives.
Information about this can be found in our home page
www.Klauke.com under 'WEEE & RoHS'.
Battery cartridges must be specially disposed of accor-
ding to the EEC Battery Guideline.
Attention
Do not dispose of the unit in your residential
waste. Klauke has no legal obligation to take
care of their WEEE outside Germany unless the
product has been shipped and invoiced from
inside your country by Klauke. Please contact
your distributer to fi nd out more how to get your
tool recycled environmental friendly.
Kontaktadresse:
WEEE-Abholung@Klauke.Textron.com
Attention
Additional instruction manuals are available
free of charge. The part # is HE.13427.
3
GB
Publicité
