Introduction - Warmup 3iE Manuel D'installation Et De Programmation

InTroduCTIon

Your thermostat's default screen is the Home Screen. This screen
displays important information such as the time, current floor and
air temperature as well as the target set temperature. From this page
you can either access the "MENU" page (press "menu") or override
the current program (press "
When using the 3IE thermostat there are some simple rules to keep
in mind:
1. Pressing " " allows you to confirm your selection
2. Pressing " " takes you back to a previous page in the menu
sequence
3. Pressing the "
setting which is highlighted
4. Pressing an illuminated button in this group will allow you to highlight another setting to edit
5. Pressing an illuminated button in this group will allow you to select another option in the menu
6. When this light is illuminated it indicates that power is being directed to the heating systems (can be
turned off).
If you do not press any button on the thermostat for 1 minute, then it will go to standby mode. In standby
mode the screen will be dimmed but the thermostat will continue to function as normal. To exit standby
mode press "wake" ( ).
The button on bottom of the 3IE (button 7) is the power button. You can turn off your thermostat and
your Warmup floor heating system by holding down this button for 3 seconds. You can turn it on again by
holding it down for another 3 seconds.
GROUND FAULT CIRCUIT INTERRUPTER
The GFCI feature is used to detect any leakage of current from your heating system. During a ground fault
the two lines of the load will be cut off. Once your thermostat is installed and connected to a power supply
you can test the GFCI function by increasing the set temperature until heating is on - the red light in the
top corner must be illuminated - and pressing the "TEST" button (see 8).
If your test is successful you will see the GROUND FAULT screen and you will need to hold "cancel" for 3
seconds in order to restore heating operation.
" or " ").
" and " " buttons allow you to change the
24/7 Technical hotline - Ligne d'assistance technique - Línea de asistencia técnica
US 1.888.927.6333 / CAN 1.888.592.7687
T ES T
3