Publicité
Installing the Wall Mount Kit
Fixing the TV panel to the wall attachment panel bracket
The shape of the product may vary depending on the model. (The assemblies of the plastic hanger and the screw are the same)
2
Remove the 4 screws on the back of the product.
Tighten the 4 screws in step 2 (plastic hanger + screw
rear holes of the product.
How to Adjust Mounting Angle
Adjust the bracket angle to -2° before installing it on the wall.
1. Fix the product to the wall bracket.
2. Hold the product at the top in the center and pull it forward (direction
of the arrow) to adjust the angle. (See the figure to the right)
3. You can adjust the bracket angle between -2° and 15°.
Insert the screw
into the plastic hanger. (See the figure below)
• Mount the product on the wall bracket and make sure it is
properly fixed to the left and right plastic hangers.
• Be careful when installing the product on the bracket as
fingers can be caught in the holes.
• Make sure the wall bracket is securely fixed to the wall, or the
product may not stay in place after installation.
Remove safety pin (
) to the
corresponding bracket holes (
that it is firmly fixed to the bracket. Make sure to reinsert and tighten
the safety pin (
) to securely hold the product to the bracket.
LCD TV
Wall Bracket
Make sure to use the top center, and not the left or the right side
of the product to adjust the angle.
English-58
) and insert the 4 product holders into the
). Then place the product (
Wall
) so
Publicité
