Publicité
10.3
orifi ce replacement
A.
Remove the cast front and the door, see "glass door /
cast front installation and removal" section in the Finishing
section of this manual.
B.
Remove the 2 securing screws indicated and remove the
burner assembly.
C.
The orifi ce is located on the left hand side.
D.
Reinstall the burner ensuring that the venturi tube fi ts over
the orifi ce and replace the screws.
E.
Care should be taken not to damage the gas pipe. When
removing and replacing the orifi ce, using a 9/16" socket
wrench, a 7/8" back-up wrench must be used on the
manifold, located below the housing, to ensure that the
aluminum tubing does not twist or kink.
10.4
care of glass
WARNING
!
•
Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
Buff lightly with a clean dry soft cloth to remove accumulated dust or fi ngerprints. Clean both sides of the glass
after the fi rst 10 hours of operation with an ammonia-free glass cleaner.
note:
Vinegar-based glass cleaners have demonstrated an ability to provide a clean, streak free glass surface.
Thereafter, clean as required. If the glass is not kept clean permanent discoloration and / or blemishes may
result. Contact you local authorized dealer / distributor for complete cleaning instructions.
Razor blades, steel wool, or other metallic objects must not be used on both surfaces of the glass. Doing so
can remove a thin layer of metal from the razor blades, steel wool, or other metallic objects that may then be
deposited onto the coating. This can result in a discoloured stain or scratch-like mark. More importantly, this can
scratch the glass surface, thereby reducing its strength.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer / distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor for
replacement parts. DO NOT SUBSTITUTE MATERIALS.
This appliance is factory equipped with 4mm tempered glass. Use only replacement parts as supplied by the
appliance manufacturer. DO NOT SUBSTITUTE MATERIALS.
maintenance
ORIFICE
LOCATION
BURNER
ASSEMBLY
SCREW
W415-2884 / A / 09.21.20
EN
35
Publicité
