Publicité
The cheek pads are affixed via three press-
studs respectively in the helmet. You can easily
remove the pads. The thicker cheek pads can
now also be affixed in the helmet with three
press-studs. You need to be able to hear that
each press-stud locks-in.
Acoustic Damping (Fig. H)
The acoustic damping (13) is for noise reduc-
tion, in particular when driving at high speeds.
Press the acoustic damping into the cavity of the
cheek pads. The acoustic side pad equipped
with Velcro faces towards the helmet shell.
Front Vent (Fig. I)
The front ventilation (6) can be opened and
closed using a slide switch.
Top Vent (Fig. J)
The top ventilation (1) can be opened and
closed using a slider.
Winter Collar
To reduce the wind inlet at the bottom of the hel-
met during periods with very cold temperatures,
the pre-installed standard collar (16) can be
replaced with the supplied winter collar (17).
Removing the standard collar (Fig. K)
Pull the one-piece standard collar towards the
inside of the helmet at the middle of one side.
Inserting the Winter Collar (Fig. L)
Insert the rod of the winter neck roll into the
opening on one side of the helmet. Fix the neck
roll almost completely. Insert the second rod
into the opening in the helmet and push in the
remainder of the neck roll.
Visor Replacement
A damaged or severely scratched visor (8) can
be replaced with a replacement visor.
Removal of the Visor
• Slide the visor into the highest position (fully
opened) (Fig. M).
• Pull the visor-locking lever and remove the
visor (Fig. N).
Inserting the Visor
• Place the replacement visor on the hold-down
device and observe the correct positioning in
the process (fully opened) (Fig. M).
• Pull the visor-locking lever and place the visor
appropriately (Fig. O).
• Allow the replacement visor to snap in and
close the visor.
Installing the Pinlock
Remove the helmet visor. Bend the visor and
place the Pinlock
lens between the two pins
®
on the helmet visor (Fig. P-Q). Allow the helmet
visor to return to its original shape. The silicone
seal on the Pinlock
lens must make full contact
®
with the helmet visor to prevent condensation
(Fig. R). Remove the protective film from the
Pinlock
lens. Reattach the helmet visor to the
®
helmet.
Adjusting the Pinlock
Remove the Pinlock
lens. To adjust the pins,
®
push the pins outward, turn with your fingers
and push back in (Fig. S).
Selecting the Correct
Helmet Size
• Measure the circumference of your head and
select the helmet size based on this measure-
ment. Try out several helmets before deciding.
Ideally, the skin on your temples will move
along when wearing the helmet.
• Ensure that even without the chin strap
secured, the helmet does not move much on
your head.
• The chin strap must be closed firmly for a
secure fit. It is fitted correctly if it is difficult to
slide your fingers under the chin strap. How-
ever, you must still be able to comfortably
breathe, swallow and turn your head.
• Verify the helmet was tested according to the
latest ECE standard.
lens
®
lens tension
®
GB
25
Publicité
