Publicité
Reversing the door swing.
Read these instructions completely and carefully.
Reversing the Hardware
Transfer Bottom Hinge Bracket to the Left
a
Pull out grille 1" (25 mm) and set it down on the
floor to gain access to the hinge bracket screws.
b
Using a 3/8" socket, remove the hinge bracket,
screws, plastic washer and spacer shim from the
bottom right side of the cabinet.
c
Remove plug button and screw from the
bottom left side of the cabinet and install at
the bottom right.
Reinstall the spacer shim, hinge bracket,
d
screws and plastic washer to the bottom left
side of the cabinet.
Transfer Center Hinge Bracket to the Left
a
Remove the center hinge bracket and shim by
removing the three screws. NOTE: Keep these
screws with the hinge bracket. They are longer
screws and will be used when installing the hinge
on the other side.
Remove the three painted screws and take
b
washers from the center left side of the cabinet.
Screw them into the holes on the right side,
which were uncovered in Step "a" above.
Place the center hinge bracket and shim over
c
the holes at the center left side of the cabinet.
Insert the three screws that were removed with
the center hinge bracket in Step "a" and
tighten securely.
Do not install the hinge pin yet.
Transfer Top Hinge to the Left
Interchange hinge and shim at top right with two
plug buttons at top left of cabinet. Do not tighten
screws on hinge side at this time.
14
(For freezer swing door models only.)
Plastic
Washer
Bottom Right
Plastic
Washer
Bottom Left
Center Right
Center Left
Publicité
