Publicité
ENGLISH
NOTICE:
WET PICK-UP ACCESSORIES SHOULD BE WASHED
PERIODICALLY, ESPECIALLY AFTER PICKING UP
WET, STICKY FLUIDS OR SPILLS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF
SOAP AND WATER.
This wet/dry vac is equipped with a float
mechanism which will rise automatically to cut
off the airflow when the liquid in the tank reaches
a predetermined level. When this happens, turn off
vac, unplug the power cord, and empty the dust
tank. You will know that the float has shut the
airflow off because the suction ceases and the
motor noise becomes higher in pitch due to
increased motor speed. The liquid capacity may
vary with the rate of pickup.
Float in raised position
IMPORTANT！
To reduce the risk of damage to the vac, do not
run motor with float in raised position.
NOTICE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM
COULD CLOSED SUCTION. IF THIS OCCURS,
PLACE VAC IN UPRIGHT POSITION AND TURN
SWITCH OFF. THIS WILL ALLOW THE FLOAT TO
RETURN TO ITS NORMAL POSITION, AND YOU
WILL BE ABLE TO CONTINUE OPERATION.
EMPTYING THE TANK
WARNING: To reduce the risk of injury from
accidental starting, unplug power cord before
emptying the dust tank.
1. Remove the power head assembly of the wet/dry
vac by pulling outward on the lid clips located on
each side of the vac.Lift off the power head
assembly.
2. Dump the tank contents into the proper waste
disposal container.
BLOWING OPERATION
WARNING: Always wear safety eyewear
complying with ANSI Z87.1 (or in Canada CSA
Z94.3) when using as a blower.
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
CAUTION: Wear a dust mask if blowing creates
dust which might be inhaled.
CAUTION: To reduce the risk of hearing loss,
wear ear protectors when using the vac/blower for
extended hours or when using it in a noisy area.
The vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or
off patios and driveways. Follow the steps below to
use the vac as a blower.
1. Locate blower port on the vac.
2. Insert one end of the 1-1/4 in. x 5 ft.
(3.2 cm x 1.5 m) hose into the blower port.
3. Turn vac "ON".
6
Publicité
