Publicité
ENGLISH
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
1. Pull lid latches in an outward motion, remove
power head and some accessories that may have
been shipped in the tank.
2. Attach accessories following the instructions in
this manual.
3. Before replacing power head, refer to this manual
to ensure you have the proper filter installed for
the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the hose.
Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) to the
extension wands. Twist slightly to tighten the
connection.
8. Plug the cord into the wall outlet. The vacuum is
ready for use.
9. To reduce the risk of injury from accidental
starting, always shut off vacuum and disconnect
the power plug from the wall outlet before
installing any part or cleaning accessory.
WARNING: Do not alter the plug in any way.
If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
WARNING: To reduce the risk of fire or
explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the
air. Flammable gases or vapors include but are not
limited to: lighter fluid, solvent-type cleaners, oil-
based paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to: coal,
magnesium, aluminum, and grain or gun powder. Do
not vacuum explosive dust, flammable or
combustible liquids or hot ashes.
Do not use this vac as a sprayer for any flammable
or combustible liquid. To reduce the risk of health
hazards from vapors or dusts, do not vacuum toxic
materials.
WARNING:
The operation of any utility vac can
result in foreign objects being blown into the eyes,
which can result in severe eye injury. Always wear
safety goggles complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach casters following the instructions below:
a. Invert dust tank. Insert casters into holes
provided in dolly until they snap into place.
b. Return dust tank assembly upright.
3. Before replacing power head, refer to this
manual to ensure you have the proper filters
installed for the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the
hose. Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. The cleaner is
ready for use.
9. Turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
O = OFF I = ON
4
Publicité
