Publicité
EN
8 Unpacking, assembling
and setting up the
appliance
✓ Take care when opening the
packaging.
✓ Remove the fan from the
packaging.
✓ Check whether the delivery is
complete (see Fig. 2).
✓ Check the fan and all the
individual parts for damage.
APPLIANCE DAMAGE
If you open the packaging carelessly
with a sharp knife or other pointed
object, the fan can be easily damaged.
Assembling the appliance
RISK OF ELECTRIC
SHOCK!
Do not connect the fan to the mains
power supply during installation.
RISK OF INJURY!
Never operate the appliance without the
protective grilles. The protective grilles
must be tightly fastened together at all
times during operation.
IMPORTANT
Observe the sequence of steps
described to ensure proper installation.
Scope of supply for
installation
3 screws (for attaching the hinge cap)
1 fixing screw with nut
Page | 18
4 rubber feet
1 pedestal foot bracket
2 screws (for attaching the pedestal foot
bracket)
Installation steps
1.
Press the 4 rubber feet into the
holes provided on the underside
of pedestal foot bracket (14).
2.
Position foot (12) in pedestal foot
bracket (14) and secure from
below with two screws.
3.
Loosen mounting nut (5) from
motor shaft (8).
4.
Push rear protective grille (7)
over motor shaft (8) and position
firmly against motor housing (9).
5.
Push mounting nut (5) onto the
motor shaft,
6.
Tighten the mounting nut in
clockwise direction.
7.
Push fan vanes (4) onto motor
shaft (8).
8.
Fasten the hinge cap to front
protective grille (2) with the
three screws.
9.
Hook front protective grille (2)
into retaining hooks (6) of rear
protective grille (7).
10.
Screw fixing screw with nut into
appliance (3) to connect the
front and rear protective grille
halves.
11.
Tighten the fixing screw.
Setting up the appliance
•
Assemble the appliance as described
in the installation instructions.
•
Set up the appliance at a distance of
at least 50 cm from other objects
(curtains, walls, spray cans).
•
Place the appliance on a firm, level
surface.
Publicité
