Purmo 51044 Guide D'utilisation page 23

03 Air.C
04 FLr.C
05 FL:Lo
Calibration of the
internal sensor
(The calibration
must be done
after 12Hours
working with the
same setting
temperature)
Calibration of the
Floor sensor
The calibration
must be done
after 12Hours
working with the
same setting
temperature.
Lower limitation of
the floor
temperature.
Only effective if
the parameter 02
is adjusted on
(FLL.1, Cb.1 and
Cb.2)
23
- To check the
temperature in the
room, put a
thermometer at 1.5M
distance to the floor in
the concerned room
and wait 1 hour to be
sure that the
thermometer show the
correct temperature.
Then you can enter the
value saw on the
thermometer with (-) or
(+) keys.
- When a calibration is
made the message
"Yes" will be displayed.
- To erase the
calibration press
simultaneity (-) and (+)
keys when "Yes" is
displayed. Now the
message "no" should
be displayed.
The calibration must
be done same as
described above if the
external sensor is
connected and used
like an external
ambiance sensor.
If the external sensor
is used as floor sensor,
the thermometer
should be put on the
floor.
Default: 18°C
Adjustable: From 5°C
to "FL:Hi"