Publicité
ENGLISH
CAUTION!
Regular maintenance will extend the life of the treadmill
and prevent injury!
TROUBLESHOOTING
The display does not show any values: Check that the sensor and
console cables are properly attached and undamaged. If this does not
solve the problem, carefully bend the sensor.
The device squeaks: Check that all bolts and nuts are tight. If necessary.
No power: Check that all cables are connected.
Motor failure: Check that the motor needs to be replaced.
Power failure: Check that the sensor cable is properly connected.
Safety Key does not work properly: Check that the safety key is
properly attached.
ERROR CODES
Err(or E00): Security key is missing from the panel or is not properly
attached.
•
Solution: Attach the security key to the yellow part of the panel.
E2: Control board is broken.
•
Solution: Replace the control board.
E4: Control board is broken.
Solution: Replace the control board.
•
E5: Short circuit in the control board or the motor is blocked.
•
Solution: Check if the motor is blocked. If this does not solve the
problem, please contact the supplier.
E6: Motor broken or motor not connected properly.
•
Solution: Check if the motor is broken or incorrectly connected,
reconnect the wiring if necessary. If this does not solve the
problem, please contact the supplier.
E7: Wires from control board to panel damaged or not connected
properly.
•
Solution: Check if the wires are connected properly and not
damaged, if necessary connect the wires again. If this does not
solve the problem, please contact the supplier.
E8: Appliance is receiving too much electrical power or is overloaded.
•
Solution: Check that the load capacity is not exceeded.
Reconnect power and restart the treadmill. If this does not
correct the problem, contact the supplier.
CONTROL PANEL (FIG. A)
CAUTION!
Make sure the safety key is properly attached before
starting the workout.
TIME
SPEED
•
COUNTDOWN MODE Press "M" to select TIME, DISTANCE or
CALORIES mode.
PRESET PROGRAM (P01-P12) Select program and press "+" or
•
"-" to set time.
Functies
TIME Displays the training time (0:00 ~ 99:59 minutes). You
•
can also set a training time (5:00 ~ 99:00 minutes). The time is
adjusted from the set value to 0, after which the treadmill
slowly stops. END" is shown in the display. The treadmill will go
into standby mode after 5 seconds.
•
SPEED Displays the speed. The speed can be increased or
decreased by pressing "+" or "-".
DISTANCE Displays the distance. A distance can also be set.
•
The distance is accumulated from 0 to the set value and then
the treadmill stops slowly. END" is displayed. The treadmill will
go into standby mode after 5 seconds.
CALORIESDisplays the calories burned. You can also set a goal.
•
The goal is counted down from the set value to 0 and the
treadmill stops slowly. END" is displayed. The treadmill will go
into standby mode after 5 seconds. The display will change
from calories burned to distance. Press "M" to select a single
display mode.
DISTANCE
CALORIES
07
Publicité
