Program Mode - Selfio FlowBox-HC Guide D'installation Et D'utilisation

Heat & Cool Mode
Use this mode to change the working mode of your installation, Heating or cooling mode.
This mode will be only displayed if:
- The CC-HC is configured to manage a reversible installation (Inst:  Parameters menu: Type, "Rev")
- No MILUX-RF HYGROSTAT is installed ( 5.3.4) and configured to manage the Heat and Cool mode.
- No CC-HC inputs (In1 or In2) have chosen for a H_C signal input. ( 5.5)
Carfull:
IF Heat pump or other system is used and not linked with the ClimaticControl-HC, pay attention to change
the working mode on it before change on the ClimaticControl-HC. Because in this case the regulation will
not work in the correct way.
TIME AND DATE – setting
In this menu you can set the actual time and date as well as the day of the week.
Using the cursor select
By keys (+) or (-) set the minutes; confirm by pressing (OK).
By keys (+) or (-) set the hour; confirm by pressing (OK)
By keys (+) or (-) set the day of the week; press (OK) to confirm.
(1 = Monday; 7 = Sunday)
6.2

Program Mode

This mode will be only displayed if no MILUX-RF Hygrostat is installed ( 5.3.4)
PROGRAM menu
In this menu you choose the program of the Controller (duration of the periods for operation in reduced
temperature and heating mode), which is to be followed in operating mode
factory set programs from P1 to P9 ( 6.2.1.) and one of the user's programs from U1 to U4.
First you select
indication starts blinking. By the keys (+) or (-) now you can select the program you need and confirm it
by pressing (OK).
User-defined Programs (U1 – U4)
If you choose one of the user programs from U1 to U4, you can program the REDUCED temperature and
NORMAL heating times directly. Proceed as follows:
The key (+) allow you to choose a COMFORT
The key (+) allow you to choose a REDUCED
At 13 the time indication blinks and day 1 is highlighted, while at 7 the time cursor blinks at 0 h on the sym-
bol (heating mode). Pressing the (-) key you can move the time cursor to the
perature mode). Then the time cursor jumps to the next hour. Thus COMFORT and REDUCED tempera-
ture cycles are selected using the (+) and (-) keys.
Using arrow keys (◄) and (►) you can select the time in the same manner.
When day 1 programming is completed the time cursor switches automatically to 0:00h of day 2. Thereby
first and then press the (OK) key.
with the help of the cursor. The indication appears at 5. Press the (OK) key and the
period at the blinking cursor time.
period at the blinking cursor time.
14
GB
. You can choose between
Day of the week.
Cursor time.
symbol (REDUCED tem-