Publicité
Balance control
The balance between the right and left-hand channels can
be set as preferred in 5 dB steps.
Press the
button (6) to adjust the balance on the left and
<
the
button (6) to adjust the balance on the right.
>
The standard setting is centered balance.
Basic attenuation
Different headphones have different sensitivity levels and
you can compensate for this with basic attenuation. What
you actually set is the attenuation you require at the max-
imum power output you want to have (which is therefore
0 dB attenuation). This setting is useful when you want
to adjust the maximum volume in user mode for a pair
of headphones or in-ear phones with a higher sensitivity
than the BE9122 Bellman Stereo Headphones or, for exam-
ple, if you want to limit the volume for a child.
Use the
button (6) to reduce the basic attenuation
>
(increase the volume) and the
basic attenuation (reduce the volume). The basic attenua-
tion is adjusted in increments of 3 dB.
The standard setting is 0 dB attenuation, which corre-
sponds to the maximum output signal.
Stereo/Mono
The line-in signal can be rendered in either Stereo or in
Mono. The intelligibility of speech can be increased in
certain listening situations, such as when watching TV, if
the signal is in Mono.
Press the
(7) button to select Stereo.
+
Press the
(7) button to select Mono.
-
The standard setting is Stereo.
Bass reduction
Low-frequency interference such as fans and road noise
can be tiring if you are exposed to it for a long period. By
activating bass reduction, low-frequency interference and
sounds are reduced.
Press the
(7) button to select Bass Reduction.
+
Press the
(7) button to deactivate Bass Reduction and
-
get level frequency response.
The standard setting is deactivated Bass Reduction.
132
button (6) to increase the
<
Adjusting the Tone Control
The Tone Control Blocking function has been developed
in case you want to make it easier for the user to use Mino.
This setting can be used to choose whether or not the user
should be able to adjust the Tone Control. If you choose
to switch off the tone control buttons, you can preset the
Tone Control that will be used in user mode.
Activation and deactivation of Tone Control
in User Mode
Press the
(7) button to activate the Tone Control buttons.
+
Press the
(7) button to deactivate them.
-
The standard setting is Tone Control activated.
Presetting the Tone Control
Press the
button (6) and the
button (6) to preset the
<
>
Tone Control to the level that will be used in user mode.
The standard setting is Tone Control centered (level
frequency response)
Please note that if the Tone Control is activated, the preset
value will be changed as soon as the Tone Control is changed
in user mode.
Blocking the T position
T
The
position can be blocked if you know that the
position will not be used. This setting is for those who will
never use the
T
position and want to avoid selecting this
position by mistake.
Press the
(7) button to activate the
+
Press the
(7) button to deactivate the
-
The standard setting is activated
T
Resetting to the factory setting
You can use this to reset all settings to the standard set-
tings the product was delivered with from the factory.
Press and hold down the
button (7) until all the LEDs
+
on the display (5) are lit. After resetting is completed, the
display will blink for a short period.
Version information
The product version information is presented here via a
pattern of lit and blinking LEDs. This internal information is
only intended as an aid for servicing and support.
T
T
position.
T
position.
App
position.
133
Publicité
