Publicité
1. Open all straps and loosen laces.
2. Pull the support over the foot (fig. 1) and lace up like a shoe (fig. 2)
3. Next, apply the stabilizing straps as follows: Lay the outer strap over
the instep and pass it from inner side under the foot (fig. 4) and attach
to the corresponding hook and loop closure on the ankle.
4. Next, lay the inner strap over the instep, pass it from the outer side
under the foot and attach to the corresponding hook and loop closure
on the ankle (fig. 5).
5. Finally, the stabilising straps are fastened at the sides (fig. 6).
5. Instructions for Use and Care:
Material: Textile pads: velour/PU; inner side of the textile: PU; hook
and loop closures: nylon straps
Cleaning: Use a slightly moistened cloth to clean the outside of the
support. Hand-wash the textile elements in 40 °C warm water with a
standard mild detergent. We recommend closing the hook and loop
closures before washing to keep them functional for a long time.
Rinse thoroughly so that all residual detergent is removed. Let air dry.
Do not expose to the sun and do not use oven or radiator heat for
drying. If need be, the shoelaces can be replaced.
Disposal after usage: Dispose the product in accordance with
national regulations. The material used in the product is recyclable and
should be disposed of accordingly.
8
Publicité
