Publicité
IMPORTANT SAFETY INFORMATION
WARNING:
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE
OPERATING THIS TOOL. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
WARNING: Failure to read, understand and follow these warnings may result in jack
stand failure resulting in death, personal injury and/or property damage.
WARNING: Do not overload jack stands beyond rated capacity. Overloading can cause
damage to or failure of the jack stands.
WARNING: POSITION LOAD ON CENTER OF SADDLE ONLY. ALWAYS USE
STANDS IN PAIRS ON HARD, LEVEL SURFACE CAPABLE OF SUSTAINING THE
LOAD. USE OF STANDS ON OTHER THAN HARD LEVEL SURFACES CAN RESULT IN
STAND INSTABILITY AND POSSIBLE LOSS OF LOAD.
Be sure all personnel are clear of load before lowering load.
Ensure that no personnel pass underneath load until load is securely supported by
jack stands.
CARE & MAINTENANCE
1. Visual inspection shall be made before each use of the stands, checking for cracks,
cracked welds and missing and/or damaged parts. Any stand that appears to be
damaged in any way shall be removed from service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE MISUSE OF
EQUIPMENT OF THIS TYPE, NO MODIFICATIONS SHALL BE MADE TO THE PRODUCT.
OPERATION
1. Refer to your vehicle owner's manual for proper jacking procedures. Lift only on areas
of the vehicle as specified by vehicle manufacturer.
2. Position stands under vehicle at points specified by vehicle manufacturer as proper load
support points.
3. To adjust stands: Hold control lever
up while lifting saddle shaft to
desired height. Push control lever
down to lock pawl into teeth located
in center column. MAKE SURE
PAWL IS FULLY ENGAGED
INTO TEETH.
4. Carefully lower load onto stands.
Saddle
Center
Column
Pawl
Control
Lever
3
Publicité
