Publicité
This quick reference guide is a fixed part of the
assembly instructions. Keep both this and the
assembly instructions in a safe place. When
passing this product on to third parties, please
be sure to include all documentation. Read the
assembly instructions before use, and pay par-
ticular attention to the safety instructions included
in the operating instructions.
You can download the assembly instructions at
the following internet link:
https://www.lidl-service.com
Package contents (Fig. A)
1 x telescopic pole (1)
2 x crossbar (2)
4 x hook (3)
1 x cap, slip-resistant (4)
4 x screw (5)
2 x washer (6)
4 x wall plug Ø 8/40 (7)
1 x hex key set (8)
1 x quick start guide
Technical data
Height variable from approx. 200-325cm
Max. frame diameter: approx. 50mm
Maximum load capacity: 30kg/crossbar
30
Date of manufacture (month/year):
05/2021
Intended use
The product is suitable as a bicycle stand for
bicycles with a maximum frame thickness of
approx. 50mm. The product has been devel-
oped for private indoor use. The product is not
intended for commercial use.
10
GB/IE
Safety information
L ife-threatening hazard!
• Never leave children unattended with the pack-
aging materials. There is a risk of suffocation.
• The product is not a toy or a climbing appa-
ratus! Ensure that persons, especially children,
do not pull themselves up on the product or
stand on it. The product can tip over.
• WARNING! Do not exceed the maximum
permitted load capacity of 30kg per crossbar!
There is a risk of injury, or damage to the
product.
• Regularly inspect all parts of the product.
Loose screws must be re-tightened and defec-
tive parts must be replaced in order to prevent
damage to the product.
• Ensure that the slip-resistant caps have no
external damage. Defective slip-resistant caps
must be replaced.
• When drilling, pay special attention to electri-
cal lines as well as gas and water lines.
R isk of injury!
• Mind your fingers in particular when installing
the product. There is a risk of injury from
crushing.
• The product may only be used under adult
supervision and must not be used as a toy.
• Ensure the product is properly stabilised
before using it.
• Check that all parts have been properly
assembled before each use.
• Use all of the fastening materials listed in
the package contents to fasten the product.
Enquire at a specialist store about suitable in-
stallation materials if a different base structure
is to be used.
• Improper installation can impair the product's
safety and functionality.
• Place the product on a flat, level surface.
• The product must not be installed on articles
of furniture.
• Check the product for damage or wear before
each use. Check regularly to make sure all
screws are tight! Only use the product if it is in
perfect condition!
Publicité
