Publicité
6. Lean the cabinet against the table. Open the door of the locker
and securely attach the locker on the wall to prevent it from tipping.
No. 2 x 4
Flat Washer
No. 4 x 4
M5 x 50mm Hex
Tapping Bolt
The installation of
the garage cabinet
set is finished.
Operation
Drawer Removal
Put the drawer out so that it's almost fully extended. Push up on the
black release lever on one side, while pulling down on the black
release lever on the other side. While holding the levers in the
positions as illustrated below, pull the drawer outward until it is
released from the drawer slide.
14
Push up one side
Drawer replacement
Extend the drawer slides from the cabinet. Insert the brackets on
each side of the drawer into the slots in the slides, being carefully to
position them properly. Once instead, close the drawer completely
to sent the slides in their proper positions.
Maintenance
1. Lubricate the slides twice a year with a quality lubricant. This is
especially necessary when the temperature drops, which may cause
the bearings to be stiff.
2. Periodically clean the drawers fronts, doors, handles and other
surfaces with mild and water.
3. For safety, use a non flammable cleaning fluid. Grease and oil
can be removed with most standard cleaning fluids.
Push down the other side
15
Publicité
