Publicité
EN
PRODUCT DESCRIPTION
1 Kettle lid
2 Kettle body
3 Control touch buttons
4 Handle
5 Base with supply cable
6 Water level indicator
7 Display
8 On/Off button
9 Temperature button
1
2
5
NOTICE:
Before first use, we recommend boiling the maximum volume of water at least 3 times and pour it out. Afterwards, the
kettle is ready for use.
The kettle may only be used with the supplied base.
36
7
3
8
9
4
6
OPERATING INSTRUCTIONS
1. Remove the kettle from the base, open the lid and fill it with cold water (the water level must be within the MIN-
MAX watermarks inside of the kettle). If you fill the kettle with too little water, it could be switched off before the
water starts boiling.
2. Place the kettle on the base. An automatic connection is made and an audible signal sounds. Thanks to the central
connector design, the kettle can turn around 360° and can be placed on the base from any side.
3. The display shows the internal water temperature when the On/Off button is pressed, the display flashes "100" and
the kettle automatically boils water to 100 °C. If you do not make another selection, the water will automatically
start boiling.
4. If you want to select temperature in range 40/50/60/70/80/90 °C, place the boiler on the base press the Temperature
button to select the desired temperature. Press the Temperature button repeatedly to increase the set temperature
by 10°. When the desired temperature is displayed, the water heating process starts automatically.
5. When the boiling point is reached, you will be alerted by a 2x beep and the kettle will automatically switch off.
6. Remove the kettle from the base and use the water.
7. If you need to reheat the water that has just been boiled, wait approximately 30 second before switching on the
kettle again.
Note:
• The heating process can be interrupted by pressing the ON/OFF button.
• A few drops of water appearing on the base of the kettle after use is not a sign of a defect. The kettle has a "Keep
warm" function (i.e. maintaining warm water temperature). Place the kettle on the base and set the required
temperature. The bottle will heat up the water until set temperature has been achieved (sound signal will be
heard). This temperature will be maintained for for 2 hours, then the kettle will be switched off automatically.
• The kettle has protection against switching on without water.
CLEANING AND MAINTENANCE
Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet! Make sure the appliance has
cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Never clean the appliance under running water, do not rinse it or immerse it in water!
Descaling
During normal use, deposition of impurities from water occurs. Use commercially available descaling agents to clean
them (follow the manufacturer's instructions).
Note: Remove the deposits regularly, approximately once a week, depending on the water hardness and frequency of
use. The deposits significantly reduce the heating capacity and the lifespan of the appliance.
EN
37
Publicité
