EINHELL GE-ST 36/40 Li E BL Mode D'emploi page 16

10. Troubleshooting guide
Problem
The cutter drum
does not rotate.
Setting the snow
guide blades does
not work (section
6.5).
Anl_GE_ST_36_40_Li_E_NA_SPK7.indb 16 Anl_GE_ST_36_40_Li_E_NA_SPK7.indb 16
EN
Cause
a) Battery is empty.
b) Battery is too cold.
c) Snow is too high and is
preventing start-up.
d) Cutter drum is iced up or full of
snow.
e) Insuffi cient contact or no
contact between the long handle
and the long handle fastener
(section 5.1).
a) Snow guide blades are iced up
or full of snow.
- 16 -
Solution
a) Replace with full battery.
b) Replace with battery at room
temperature.
c) Lift the cutter drum a little from the
snow before switching on.
d) Carefully free the cutter drum from ice
and snow; let it thaw if necessary.
e) Open the long handle connection,
remove the long handle and check the
contacts. Refasten the long handle.
a) Carefully free the snow guide blades
from ice and snow; let them thaw if
necessary.
04.06.2024 14:36:57 04.06.2024 14:36:57