Publicité
Note:
1. All indicators light on and blink for 2 seconds simultaneously if the factory
settings are restored successfully.
2. Wi-Fi hotspot indicator blinks for 2 seconds if the printer Wi-Fi hotspot
password is reset successfully. Reset the network only when printer is idle
or there is a printer failure. Default password is 12345678.
3. During printing, printing will not be interrupted when the power button is
pressed.
4. During firmware upgrading, upgrading will not be interrupted when the
power button is pressed.
5. When there is a failure, press the power button to power the printer off.
Then, power the printer on again. The printer will try to fix the problem
automatically after powering on. If fail to power the printer off, please use
a pin to poke the reset hole at the back of the printer to restart.
Power Indicator
Light off
Light on
White light blink
Breath
Note:
• Sleep mode starts after idle for 5 minutes. Press Power Button or send a
print job to wake the printer up .
• Auto-power off after idle for 20 minutes .
Failure Indicator
Light off
Orange light blink
Battery Indicator
Light off
Orange light on
White light on
White light blink
Orange light blink
Power off
Power on
Printing
Firmware upgrading
In sleep mode
Printer OK
Printer has failed. Follow the APP
prompts to solve problem
Fully charged
Low battery
Charging
Battery error state
Battery insufficient
07
Publicité
